English
Designed by Van de Stadt this Jupiter 30 was built around 1980. Competitive cruiser/racer with a good performance that offers also a comfortable interior for family cruising.
Yes - she is not in her first flush of youth but she has been regularly maintained by her current owner and now represents an opportunity for a new owner! She has also had some upgrades since the photos were taken - including new upholstery... continuous annual upgrades.
Construction
GRP with gel coat finish - blue hull and white deck. Fin keel.
Self draining cockpit
Interior joinery in teak and mahogany
Trim on deck in teak
Rudder bearings were replaced in 2017
Mahogany rubbing strake replace 2018
Dimensions and Tankage
Length Overall: 8.96m / 29'4"
Length at Waterline: 7.53m / 24'8"
Beam: 3.17m / 10'4"
Max Draft: 1.55m / 5'1"
Displacement: 4394kg
Tankage -
Fuel: 50l
Water: 100l (flexible tank)
Engine
Yanmar YSE 12hp - with a reputation for economy of operation.
Stern gland and exhaust elbow both replace in 2015
Prop: 2-blade folding in bronze
Engine last serviced - summer 2018 and is due to be serviced again in summer 2019
Rudder bearings were changed in 2018
Accommodation
The saloon is offset to port with a linear galley and nav station to startboard. There is a large aft/quarter berth to starboard aft of the nav station.
The saloon seating (seats 5-6) also converts for use as a double berth. Heads is by the companionway on the starboard side and a good size.
The forecabin has a closing sliding door, and has 2 large single berths with insert conversion to large double berth with large hanging lockers on either side.
Good stowage beneath the v-berth.
Galley has a gimballed 2 burner gas cooker with oven and grill. There is also a microwave oven - Russell Hobbs. Good storage.
Stainless steel sink. Water system is cold water and manual. Currently no fridge/coolbox.
Chart table with map reading light and chart storage
3 large dry food storage lockers under seating in moulded white GRP
Double skin insulation throughout and Eberspacher heating.
Ventilation port in main cabin, forward cabin and heads
Upholstery replaced 2017 now white - and brings in a lot more light.
Sails and Rig
Masthead sloop with slab reefing main with lazy lines and stack pack - all new in 2016 by Sketrick.
Furling genoa with facnor SD150 furling system. UV strip replaced 2015.
There is also a 2nd genoa and a cruising chute.
Black Aluminium mast and boom with stainless steel standing rigging. Backstay tensioner.
Spinnaker boom.
Last change of standing rigger - not known
Features
- Radar reflector
- Shore power inlet
- Wind speed and direction
- Heating
- Tender
- Electric bilge pump
- Marine head
- Lazyjacks
- Microwave oven
- Plotter
- Tiller
- Gps
- Radar detector
- Oven
- Liferaft
- Battened mainsail
- Outboard engine brackets
- Swimming ladder
- Lazy bag
- Compass
- Autopilot
- Manual bilge pump
- Log speedometer
- Battery charger
- Inverter
- Spinnaker
- Spinnaker pole
- Furling genoa
- Depthsounder
- Vhf
Contact Information
Contact John now - on +44(0)7564 366 639