English
Vancouver 27, 1979
Long keel with transom-hung rudder, tiller steering, masthead rig with slab reefing mainsail and furling headsail.
The Vancouver 27 is a ‘go anywhere’ pocket cruiser. This sturdy 27-foot cutter was squarely aimed at couples looking to sail the world’s oceans. Purpose built for exactly this purpose, the first boat sailed successfully from British Columbia to New Zealand and back. More than 250 were built.
Mechanical
Buhk DV 20 20hp Diesel Inboard
Engine hauled out and rebuilt May 2019
Shaft drive
Fixed 3 blade prop
Fuel tank cleaned and fuel polished December 2023
2 new valves, valve seats reground and head gasket - 2022
New prop, stern tube and cutless bearing - 2022
Electrical
2 x 75 amp/hr batteries for the engine and domestic - 2020
Engine alternator
12v electrical system
Around 75% of the wiring has been replaced, and much redundant cabling removed.
The main switch panel was rewired
Battery monitoring - BM1
Equipment
Navigation
Icom IC-M601 VHF / DSC
Raymarine RC530 Chartplotter
Speed/Depth - Clipper Duet
Wind - Clipper
Compass
Raymarine autopilot - untested
AIS transponder that is connected to a Raspberry Pi running OpenCPN - 2021
Deck
Teak laid cockpit seating and sole
Teak toe rail and grab handles
Tiller steering
S/S push and pull pit
Guard wires
2 x Gibb ST winches for genoa
2 x Gibb coachroof winched for halyards
Swim ladder
Dorade vents x 3
Manual windlass
Anchor and chain
Lift raft holder
Canvas
Sprayhood
Safety
Manual Bilge pump
Horseshoe lifebuoy
Miscellaneous
The hull was grit blasted, filled, faired and copper coated over the winter of 2021/22 at Deacons
2.7m Seago tender - by separate negotiation
EPropulsion electric outboard - by separate negotiation
Rig
Masthead sloop rig
Aluminum mast and boom
Most lines lead aft
Single spreader
S/S standing rigging - New 2012
Inner forestay
Spinnaker pole
Sails
3 mainsails - two standard and one fully battened (bought second hand in 2021 as part of a set including the currently fitted yankee, a furling staysail and the main)
Yankee
Genoa
Hank on staysail
Cruising chute
Storm jib
Storm trisail
Accommodation
Four berths - 2 in saloon plus Port and Starboard quarter berths
Forepeak
Forepeak for sail stowage access to the chain locker forward.
Marine toilet
Wash basin with pressurised cold water tap and shower
Hanging and stowage.
Saloon
Generous berth to starboard and port
Double flap table on the center line
Shelving
Galley
Stainless steel sink with drainer and foot pumps for fresh and salt water
Two burner cooker with grill and oven
Gas pipes were all replaced 2020
New flexible water tank 2020
Chart Table
Large chart table with stowage for charts
Construction
Northshore built hull, finished by Fion Yachts in 1979/80
GRP Hull, Deck and Coachroof
Dimensions
LOA: 28 ft 0 in
Beam: 8 ft 8 in
LWL: 22 ft 11 in
Maximum Draft: 4 ft 6 in
Displacement: 4064 kgs
Tankage
Fresh Water Tanks: 1 (75 Litres)
Fuel Tanks: 1 Stainless steel (150 Litres)
Documentation
Bills of Sale - Evidencing 5 years clear title
Berthing letter - Evidencing UK location - 31.12.20
SSR certificate - Expired (First Registered 1985)
For a full, detailed specification with additional photographs and direct contact details for the listing office visit our website
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Unless otherwise stated on the specification sheet the following presumptions are made
Sail drive and shaft seals are more than 5 years of age
Fuel and gas hoses and regulators are over 5 years old
Standing rigging and sails are more than 10 years old
NOTE - Please ring our offices prior to visiting, as the boat may be unavailable for viewing or located at a different marina.