English
uilt in 1972, Tanis was refitted by Jeremy Rogers in 2010/2011 and re-engined by Bucklers Hard Boat Builders in 2017. Her Yanmar 1GM10 has done approximately 50 hours. In Tip top condition she has been loved and maintained to a high standard. With a recent survey available , she has had recent additions which add to the value of a classic boat of this nature
Mechanical
MECHANICAL
2017 Yanmar 1GM10 (Engine 1) 2017
Engine Type: Inboard
Fuel Type: Diesel
Hours: Approx 50 since replacement
Power: 9 hp
Prop: 3 blade Bronze
New Yanmar 1GM10 fitted by Bucklers Hard Boat Builders in 2017.
ELECTRICAL
12v
2 x 12v batteries replaced 2017.
6 gang Fuse box
Interior lights
Running lights
Rig
RIG
Sloop Rig
Aluminium Mast, Boom & Spinaker pole
New standing rigging fitted 2009 (Jeremy Rogers).
SAILS
New main and genoa halyards 2011
Banks sails – Main (slab reefing), Genoa, Jib, Storm Jib, Spinnaker & pole.
2 Speed Lewmar Genoa and Halyard winches.
Equipment
NAVIGATION & ELECTRONICS
Depthsounder
Log-Speedometer
Wind Speed and Direction Stowe depth & wind instruments fitted on mast.
Autopilot: Tiller Pilot
Autohelm ST1000+,
Compass
VHF: Icom IC330 with DSC ( 2021 )
EXTERIOR EQUIPMENT
Covers:
New Sprayhood in 2019.
Dodgers
Sail cover
Teak Cockpit: Teak cockpit grating
Cockpit Cushions
Swimming Ladder
Lewmar Deck Hatch
Stainless pulpit and Pushpit
Assorted Fenders and Mooring lines
SAFETY
manual Bilge Pump
NEW ADDITIONS & MAINTENANCE
Minor survey items addressed
Antifoul
New 9" Raymarine Chart plotter
New Wallus 1300 heater
Serviced seacocks
Service kit for engine available
only 50hrs from new
New cutlass bearing
New hull anode
Electrics and earthing checked
New Lewmar anchor
3 jibs spinnaker and main
Previous owner spent 40k over the years with the manufacturers on maintenance
Accommodation
GALLEY
Oven: Plastimo Coral Stainless Two burner gas hob and Grill
Water Spout
HEADS
Jabsco Manual flush Sea Toilet
Heads (wc) replaced 2008.
SALOON
New saloon cushions fitted & cabin varnished 2010 (Jeremy Rogers)
Extendable Chart Table
Chart Drawer
Book shelf
Dryhanger space
Construction
CONTESSA 26
Year : 1972
"TANIS"
CONSTRUCTION
Rogers, CO 280, 1972, British Registered.
O.N. 378933
R.T. 3 83/100
Hull & Deck: GRP/Fibreglass
Length Overall: 7 m 77 cm
Length At Waterline: 6 m 10 cm
Beam: 2 m 13 cm
Minimum Draft: 1 m 22 cm
Max Draft: 1 m 22 cm
Weights
Ballast: 2750 lb
Displacement: 5000 lb
Speed
Cruising Speed: 5 kn at rpm
Hull Speed: 6 kn at rpm
Accommodation
Single Berths: 4
Cabins: 2
Heads: 1
Other
Flag of Registry: United Kingdom
Builder: Jeremy Rogers
Steering: Tiller
Keel: Long Cruising
Full osmosis treatment 2010 (Jeremy Rogers)
New teak cabin floor 2010 (Jeremy Rogers)
Repaired main beam under mast 2010 (Jeremy Rogers)
New windows fitted 2010 (Jeremy Rogers)
New forehatch fitted 2010 (Jeremy Rogers)
New capping rails fitted 2008.
New stainless steel fuel tank fitted 2010.
New rudder fitted 2009 (Jeremy Rogers).
New gas piping fitted 2009 (Jeremy Rogers).
Awlgrip 2-pack ‘Aristo’ topsides painted in 2000.
Stern draining gas bottle installation
Teak Cockpit: Teak cockpit grating
For a full, detailed specification with additional photographs and direct contact details for the listing office visit our website
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Unless otherwise stated on the specification sheet the following presumptions are made
Sail drive and shaft seals are more than 5 years of age
Fuel and gas hoses and regulators are over 5 years old
Standing rigging and sails are more than 10 years old
NOTE - Please ring our offices prior to visiting, as the boat may be unavailable for viewing or located at a different marina.