Beneteau Oceanis 430

Beneteau Oceanis 430
SAILS :
- full batten main sail
- Genoa on roller furling system GOIOT
- new main sheet and reef lines
RIGGING :
In 2003, complete original Bénéteau standing rigging (grément dormant complet)

ENGINE :
- PERKINS 4108 50 HP,
- fuel tank : 200 L
- 3 blades propeller
ELECTRICAL :
- 12 V circuit
- 2 service batteries and 1 starter battery
- inlet for connection to 220V circuit
- 1 solar panel on deck, to be connected
FRESH WATER TANKS :
600 L in 4 tanks
SAFETY EQUIPMENT: all equipment of first category
- life-raft for 10 people in bag
- distress signal kit
- 8 life jackets and life belts
- 2 horseshoe buoys
- 2 fire extinguishers
- automatic electric RULE bilge pump, engine-related bilge pump and manual bilge pump
- EPIRB
- INMARSAT satellite telephone SP2000M

ANCHORING :
- WINDLASS LOFRANS anchor winch 1000W with remote control
- 200 ft of chain, diameter 3/8, with FOB anchor
- spare anchor with chain and rope
CABINS:
2 fore cabins and 2 aft cabins with double-bed, 2 cupboards, sink with fresh water, mirror
BATHROOMS:
2 (star-board and port-side, behind fore cabins) with toilet and cold/hot shower
ELECTRONICS :
- autopilot
- 2 GPS GARMIN, 1 fixed and 1 mobile
- fixed V.H.F RADIO and world receiver
- radio cassette and 12 CD- changer, with 2 external loudspeakers and 2 loudspeakers in the saloon
- INMARSAT satellite telephone
GALLEY:
- refrigerator 12 V, with new compressor (2003)
- stainless steel stove and 4 gas cylinders
- possibility for fresh or sea water at the tap
- all kitchen ware
- stainless steel charcoal barbecue outside

REAR OF THE BOAT:
with deck-shower, around 40 cm wide bathing platform with storing room underneath it
DINGHY:
- Zodiac Zoom 310 S of 2001
- engine Yamaha 4 ACMHS of 2001
OTHER EQUIPMENT
- new Olympia steering compass
- stainless steel railing charcoal barbecue
- 6 fenders
- brass watch and barometer
- many spares and tools
- cockpit cushions and covers
- deck shower
- fishing rod and equipment
- all kitchen ware
- mattresses, cushions and linen
- sea charts of Tanzania

IMPORTANT WORKS ON THE BOAT:
RIGGING: Complete replacement in 2003
OSMOSIS: Complete treatment in 2003
INSIDE FLOOR: complete new floor in red cedar 2003 (galley, saloon and 4 cabins, door of the fridge)
VARNISH: the whole inside wood work 2005 (galley, walls, ceiling, doors)
RUDDER: serviced completely in 2001
ANCHOR PLATE : new in 2000
SEA COCKS: all new in 2003
SALOON: new cushion covers in thick yellow material 2003
COCKPIT: foam cushions with plastic covering and blue material cushion covers made in 2001

repairs
Work programme to bring Wimbi Nyota functionally up to scratch/ May 2008/ quote by Kilifi boatyard


1.PAINTING

Sand the hull, apply one coat of HB 2 pack epoxy primer, make good to any imperfections in the gel coat of the hull, spray paint the hull with 2 pack imported Barocryl white top coat, re-do the boot top and the top stripe.

2.Below the waterline, sand the antifouling down to a smooth surface, check if there is any blistering in the gel coat and if necessary repair (very improbable). Apply two coats of Jotun red Seaforce self polishing antifouling.

3.On the deck and cockpit
a.Replace 4 bases of stanchions and refit the life lines

4.In the cabins:
a.Remove the PVC headlining in the sleep cabins, fore and aft. Clean the surface underneath and paint white with as many coats of epoxy primer as needed to get a nice clean looking surface (which however will not be smooth)
b.Service the cooker and make it operational
c.Check the working of the pressurised water system and repair if necessary
d.Remove the hot-water boiler if wanted
e.Check the working of the fridge and repair if necessary Check the working of the bilge pumps and repair or replace if necessary

5.Anchors
a.Refit the anchor roller
b.Check the condition of the anchor chain, if badly rusted have it re-galvanised
c. Buy second hand anchor winch

6.Engine and electrics
a.Check the condition of the electrical wiring and repair where necessary
b.Supply 4 new ordinary batteries of 95 or 100 AmpH
c.Remove the engine from the boat and overhaul it. Re-fit the engine

7.Life raft
a.Have life raft serviced by African Marine

8.Mast, winches and rigging
a.Service the furling gear and repair the aluminium tube
b.Service all the winches


Our quotation for the above work is € 7500. The quotation does not does not include the cost of a second hand anchor winch, because the only second hand winch we have is a manual winch. The cost of a new electric winch depends on the kind you buy, but it will not be less than € 1000.
We hope that we will be able to repair the aluminium tube of the furler. We may have to improvise something.